5/28/2023 0 Comments Ispectrum user manualVOLCable Box Icon = To lock volume controls to the cable box, Press MUTE.Audio Icon = To lock volume controls to the audio device, Press.TV Icon = To lock volume controls to the TV, Press VOL +.Press the key below for the device that you wish to use for volume controls:.If you wish to change volume control settings from these defaults, perform the following steps: If the remote is also set up to control an audio device, then volume controls will default to that audio device. The remote is set to default to control TV volume once the remote is programmed for a TV. If not, repeat this process using the next code listed for your brand. If the device responds as expected, setup is complete. The INPUT KEY will blink twice to confirm once complete. Enter the 1st code listed for your brand.Show remote with MENU and OK keys highlighted Ensure that your TV and/or audio device is powered-on.For faster setup, be sure to locate your device brand in the code list before beginning setup. This step covers setup for all TV and Audio brands. NOTES: While holding the digit key, the remote will test for the working IR code, causing the INPUT key to flash each time it tests a new code. Show remote pointed at TV, transmitting data and TV is off Release the digit key when the TV turns off.Find your TV brand in the chart below and note the digit that relates to your TV brand.Simultaneously press and hold MENU and OK keys on remote until the INPUT key blinks twice.If your brand is not listed, please proceed to SETUP USING DIRECT CODE ENTRY This step covers setup for the most common TV brands. Show remote with MENU and 3 keys highlighted Programming Your Remote for TV and Audio Control Press and hold MENU and the 3 digit key simultaneously until the INPUT key blinks twice.If your cable box is branded Cisco, Scientific Atlanta, or Samsung:.Show remote with MENU and 3 keys highlighted Press and hold MENU and the 2 digit key simultaneously until the INPUT key blinks twice.If your cable box is branded Motorola, Arris, or Pace:.If the cable box responds, skip this step and proceed to PROGAMMING YOUR REMOTE FOR TV AND AUDIO CONTROL. Point your remote at your cable box and press MENU to test. If you have a WorldBox, refer to the section above for remote pairing, following the on-screen instructions for any other remote programming. This section is for any cable box that is NOT a Charter WorldBox. More detailed information about the system performance and health is available in " Health Monitoring".Programming Your Remote for Any Other Cable Box The server monitor item provides a visual indicator if an aspect of server functions reaches a critical level. Alternatively, use Ctrl + Click to highlight multiple servers, then open the context menu to select Monitor. To view the health of all available s ervers in a single l ayout, use Ctrl + Click to highlight multiple servers and Click-and-drag them from the Resource Tree into a layout. Multiple servers can be monitored simultaneously. A trace can be enabled or disabled by checking the box next to its name, and when the mouse cursor is hovered over a name, the corresponding trace will be highlighted while all other traces will be grayed out.
0 Comments
Leave a Reply. |